Previous photo Next photo Thumbnail page
Neidrauer Adventures Photo Album » Building a Live Steam Locomotive - the Mikado Project » Section 15 - Cab
IMG_4528 IMG_4495 IMG_4492 IMG_4491 IMG_4489 IMG_4488 IMG_4487 IMG_4486 IMG_4485 IMG_4483 IMG_4481 IMG_4478 IMG_4475 IMG_4473 IMG_4455 IMG_4453 IMG_4452 IMG_4451 IMG_4447 IMG_4446
First page Previous page Index page Next page Last page
IMG_4481  [27 of 52]


Click to show/hide keyboard shortcut help
Keyboard shortcuts are active:

RIGHT arrow - next page
LEFT arrow - previous page
Page Up - index page
HOME - first page
END - last page
ESC,S,s - toggle start/stop slide show
ExhibitPlus IMG_4481
27-Aug-2012 Another machinist's tip was revealed tonight. In order to mimic the Frisco window style, we needed to mill the left and right sides to a 5 degree angle. Set the 5 degrees on the protractor. place the fixed edge against the workpiece. Install a dial test indicator on the spindle and rest the pointer on the ruler. Traverse the table in the Y direction (front to back). If the ruler is aligned with the table, the dial test indicator will stay at zero. If not aligned, bump the workpiece around in the needed direction until you get a zero reading. Lock the workpiece down and mill your angle!

IMG_4528 IMG_4495 IMG_4492 IMG_4491 IMG_4489 IMG_4488 IMG_4487 IMG_4486 IMG_4485 IMG_4483 IMG_4481 IMG_4478 IMG_4475 IMG_4473 IMG_4455 IMG_4453 IMG_4452 IMG_4451 IMG_4447 IMG_4446
First page Previous page Index page Next page Last page